WEB开发网
开发学院网络安全防火墙 配置PIX Failover(三) 阅读

配置PIX Failover(三)

 2008-12-18 12:18:55 来源:WEB开发网   
核心提示: pix(config)# show failoverFailover OnCable status: NormalReconnect timeout 0:00:00Poll frequency 15 secondsThis host: Primary - ActiveActive time

  pix(config)# show failover
  Failover On
  Cable status: Normal
  Reconnect timeout 0:00:00
  Poll frequency 15 seconds
  This host: Primary - Active
  Active time: 253515 (sec)
  Interface faillink (192.168.3.1): Normal
  Interface outside (172.23.58.70): Normal
  Interface inside (192.168.2.1): Normal
  Other host: Secondary - Standby
  Active time: 0 (sec)
  Interface faillink (192.168.3.2): Normal
  Interface outside (172.23.58.71): Normal
  Interface inside (192.168.2.2): Normal
  Stateful Failover Logical Update Statistics
  Link : faillink
  Stateful Obj xmit xerr rcv rerr
  General 34177 0 34183 0
  sys cmd 34175 0 34173 0
  up time 2 0 2 0
  xlate 0 0 0 0
  tcp conn 0 0 8 0
  udp conn 0 0 0 0
  ARP tbl 0 0 0 0
  RIP Tbl 0 0 0 0
  >
  Logical Update Queue Information
  Cur Max Total
  Recv Q: 0 1 34184
  Xmit Q: 0 1 34179
  >
  LAN-based Failover is Active
  interface dmz (171.69.39.200) Normal, peer (171.69.39.201): Normal:
  

命令show failover lan可以只显示基于LAN的failover的状态。命令show failover lan detail提供了更为详细的信息,

例2 show failover lan detail命令输出:

  pix(config)# show failover lan detail
  Lan Failover is Active
  This Pix is Primary
  Command Interface is dmz
  Peer Command Interface IP is 171.69.39.201
  My interface status is 0x1
  Peer interface status is 0x1
  Peer interface downtime is 0x0
  Total msg send: 103093, rcvd: 103031, droped: 0, retrans: 13, send_err: 0
  Total/Cur/Max of 51486:0:5 msgs on retransQ
  msgs on retransQ if any
  LAN FO cmd queue, count: 0, head: 0x0, tail: 0x0
  Failover config state is 0x5c
  Failover config poll cnt is 0
  Failover pending tx msg cnt is 0
  Failover Fmsg cnt is 0

上一页  1 2 3 4  下一页

Tags:配置 PIX Failover

编辑录入:爽爽 [复制链接] [打 印]
赞助商链接